Cisco 6921 - Unified IP Phone Standard VoIP Administration Manual page 141

Appendix D Basic Phone Administration Steps
Adding a User From an External LDAP Directory
If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you
can immediately synchronize that directory to the Cisco Unified Communications Manager on which
you are adding this same user and the user's phone by following these steps:
Procedure
Log onto Cisco Unified Communications Manager Administration.
Step 1
Choose System > LDAP > LDAP Directory.
Step 2
Use the Find button to locate your LDAP directory.
Step 3
Step 4 Click on the LDAP directory name.
Step 5 Click Perform Full Sync Now.
Note
Proceed to
Step 6
Adding a User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications
Manager Administration by following these steps:
Procedure
Choose User Management > End User, then click Add New. The End User Configuration window
Step 1
appears.
In the User Information pane of this window, enter the following:
Step 2
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
OL-19025-01
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified
Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP
Directory window determines when the next auto-synchronization is scheduled. However, the
synchronization must occur before you can associate a new user to a device.
"Configuring the Phone" section on page
User ID—Enter the end user identification name. Cisco Unified Communications Manager does
–
not permit modifying the user ID after it is created. You may use the following special
characters: =, +, <, >, #, ;, \, , "", and blank spaces.
Example: johndoe
Password and Confirm Password—Enter five or more alphanumeric or special characters for the
–
end user password. You may use the following special characters: =, +, <, >, #, ;, \, , "", and
blank spaces.
Last Name—Enter the end user last name. You may use the following special characters: =, +,
–
<, >, #, ;, \, , "", and blank spaces.
Example: doe
Telephone Number—Enter the primary directory number for the end user. End users can have
–
multiple lines on their phones.
Adding a User to Cisco Unified Communications Manager
D-4.
D-3