The Timer - Hotpoint EW92 Instructions For Installation And Use Manual

Electronic Clock & Automatic Oven Timer
Operation
Note 1 When cooking automatically the Cook Period can be checked at any time by simply pressing
the Cook Period button.
OTHER NOTES ON TIMER OPERATION
1. When cooking Automatically the Cook Period can be checked at any time simply by pressing the Cook
Period button.
2. When cooking Automatically the End Time can be checked at any time by simply pressing the End Time
button.
3. Having set a Cook Period and End Time an electronic device stores the information. The device within the
timer will switch the oven(s) on and off at the required times.
4. When setting an Auto Cooking Programme and a mistake is made, to clear:–
(a) Press and hold in the
(b) With the Cook Period button still held in, return the display to
(c) Release the
flash.
(d) Press & release the
(e) Start the sequence again.
5. If at any time the display shows three flashing zero's 0.00. It is likely that the electricity supply to the oven
has been interrupted. Reset the timer to the correct time of day.
Food in the oven may, therefore, not have been cooked, before serving check food is thoroughly heated
and completely cooked.
6. To set each function always press and hold the required function button and at the same time press "+" or
"–" buttons.
Note: Between the hours of 22.00 & 06.00 the display dims to prevent glare.
However, if you should operate a button during this period, the timer will return to normal
brightness for a few seconds and then dim again.
TO CANCEL AN AUTO COOKING PROGRAMME BEFORE
THE COOK PERIOD HAS FINISHED.
Step 1 Turn the oven control(s) to the OFF position.
Step 2 Press and hold in the
Step 3 With the
the "–" button.
Step 4 Release the
day and the "Auto" symbol will flash.
Step 5 Press the
The "Auto" symbol will go out.
button.
& "–" buttons, and the display will revert to the time of day and the "Auto" symbol will
button.
button.
button still held in, return the display to 0.00 by pressing
and "–" buttons and the display will revert to the time of
button to return the oven(s) to "Manual" operation.
A
U
by pressing the "–" button.
T
O
17