Installation; Installing The Unit; Mounting With Brackets; Mounting With Velcro Tape - Pioneer AVM-P7000R Manual

• Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up
properly, and the unit and the system work properly.
• Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation requires the drilling of holes or other modifications of
the vehicle.
• Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• When mounting this unit, make sure none of the leads are trapped between this unit and the
surrounding metalwork or fittings.
• Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors,
where rainwater might splash onto it.
• Before drilling any mounting holes always check behind where you want to drill the holes. Do not
drill into the gas line, brake line, electrical wiring or other important parts.
• If this unit is installed in the passenger compartment, anchor it securely so it does not break free while
the car is moving, and cause injury or an accident.
• If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads
and cords carefully around the sliding mechanism so they do not get caught or pinched in the
mechanism and cause a short circuit.

Installing the Unit

Mounting with Brackets

Car mat or chassis
E
Tapping screw (4 12 mm)
Screw
E
(4 8 mm)
Bracket
Drill 2 to 2.5 mm diameter holes.

Mounting with Velcro Tape

• Thoroughly wipe off the surface
before affixing the velcro tape.
Velcro tape
Car mat or chassis