Pioneer AVX-P7300DVD Installation Manual

AVX-P7300DVD
This product conforms to CEMA cord colors.
Le code de couleur des câbles utilisé pour ce produit est
conforme à CEMA.
Printed in Japan
Imprimé au Japon
<CRD3479-A> UC <KYMFF/01D00000>
Connecting the Units
Note:
• This unit is for vehicles with a 12-volt battery and • To prevent incorrect connection, the input side of
negative grounding. Before installing it in a recre-
the IP-BUS connector is blue, and the output side
ational vehicle, truck, or bus, check the battery
is black. Connect the connectors of the same
voltage.
colors correctly.
• To avoid shorts in the electrical system, be sure to
• If this unit is installed in a vehicle that does not
disconnect the ≠ battery cable before beginning
have an ACC (accessory) position on the ignition
installation.
switch, the red lead of the unit should be connected
• Refer to the owner's manual for details on to a terminal coupled with ignition switch ON/OFF
connecting the power amp and other units, then operations. If this is not done, the vehicle battery
may be drained when you are away from the vehi-
make connections correctly.
cle for several hours. (Fig.1)
• Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake and
seat rails. Do not route wiring in places that get
hot, such as near the heater outlet. If the insulation
of the wiring melts or gets torn, there is a danger of
the wiring short-circuiting to the vehicle body.
ACC position No ACC position
• Don't pass the yellow lead through a hole into the
engine compartment to connect to the battery. This
will damage the lead insulation and cause a very
dangerous short.
• Do not shorten any leads. If you do, the protection
circuit may fail to work when it should.
• Never feed power to other equipment by cutting
• Cords for this product and those for other products
the insulation of the power supply lead of the unit
may be different colors even if they have the same
and tapping into the lead. The current capacity of
function. When connecting this product to another
the lead will be exceeded, causing overheating.
product, refer to the supplied Installation manuals
• When replacing fuse, be sure to use only fuse of of both products and connect cords that have the
the rating prescribed on the fuse holder. same function.
• If the RCA pin jack on the unit will not be used, do
not remove the caps attached to the end of the con-
nector.
When Connecting the Multi-Channel AV Master Unit
Multi-Channel AV
Master Unit (e.g. AVM-P9000R)
(sold separately)
Green
Red (Right)
White (Left)
Yellow
Blue
Yellow
Fig. 1
Blue
Red
IP-BUS cable
(supplied with the TV tuner)
FM MODULATOR
IP-BUS MAIN UNIT
IP-BUS AV MASTER
RCA cable
(sold separately)
Red
20 pin cable
(supplied with the TV tuner)
Gray
Connection box
RGB cable
(supplied with the DVD
(supplied with the Multi-
Navigation Unit)
Channel AV Master Unit)
Red Green
To video output
To audio outputs
RCA cables (sold separately)
Yellow/black
To Yellow/black lead (GUIDE ON)
on the navigation unit.
Optical cable
(supplied with the Multi-
Channel AV Master Unit)
Black
Blue
Hide-away TV Tuner
(e.g. GEX-P7000TV)
RCA cable (supplied)
(sold separately)
6 m
IP-BUS cable (supplied with the
Green
Multi-Channel AV Master Unit)
AV cable
(supplied with the
Multi-Channel AV
Gray Green
Master Unit)
<ENGLISH>
DVD Navigation Unit
(e.g. AVIC-9DVD)
(sold separately)
Voice guidance speaker
(supplied)
Multi-CD player
(sold separately)
3 m
Blue
This product
40 cm
Black
Not used.
Blue 40 cm
16 cm
Yellow
(AVM OUTPUT)
20 pin cable
Red
3 m
(supplied)
Fig. 2