Connecting the Units ... 2 Connecting the system ... 3 Connecting the power cord (1) ... 5 • PIONEER does not recommend that Connecting the power cord (2) ... 7 you install or service your display your- When connecting to separately sold power self.
Connecting the Units Connecting the system Antenna jack Blue IP-BUS input AV-BUS input (Blue) (Blue) Violet Blue Hilde-away unit (supplied) Blue IP-BUS cable (supplied with XDV-P6) AV-BUS cable (supplied with XDV-P6) Blue Blue IP BUS STAND ALONE Hide-away unit (supplied with XDV-P6) Black AV-BUS cable (supplied with TV tuner)
Connecting the Units Connecting the power cord (1) TEXT 003 xxxxxxxxxxxxxx xxxxxxxxxxxx xxxxxxxxxxxx xxxxxxxxxxxx xxxxxxxxxxxx xxxxxxxxxxxxxxxx Power supply wiring kit “RD-221” (sold separately) Fuse(1A) Relay Black (ground) Black (ground) To vehicle (metal) body. To vehicle (metal) body. Yellow Fuse Power is always supplied (20 A) to this terminal.
Connecting the Units Connecting the power cord (2) TEXT 006 xxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxx Hilde-away unit (supplied) TEXT 007 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx Left Gray White Tweeter (FRONT HIGH ≠ OUTPUT) Gray/black White/black Black/white Black/white Front center speaker (FRONT CENTER ≠...
Connecting the Units When connecting to separately sold power amp Hide-away unit (supplied) See the section “Connecting the power cord (2)”. Blue/white To system control terminal of the power amp (max. 300 mA 12 V DC). System remote control TEXT007 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx...
(sold separately) To video output Hilde-away unit (supplied) See the section “Connecting the power cord (2) CAUTION Pioneer recommends the use of a camera which outputs mirror reversed images, otherwise screen image may appear reversed. Extension lead (supplied) 15 cm...
Connecting the Units When connecting the external video component and the display To video output Hide-away unit To audio outputs Video input 2 Video input 1 To audio outputs To video output • It is necessary to set to AV INPUT 1 and AV INPUT 2 in SETUP when connecting the external video component.
Installation Note: • When mounting the hide-away unit, make sure none of the leads are trapped between the hide- • Before making a final installation of the unit, temporarily connect the wiring to confirm that the away unit and the surrounding metalwork or fit- connections are correct and the system works tings.
Installation 2. Install the unit into the dash- DIN Rear-mount board. (Fig. 14) After inserting the holder into the Installation using the screw holes on dashboard, then select the appropriate the side of the unit tabs according to the thickness of the dashboard material and bend them.
Page 11
TEL: (03) 9586-6300 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R OP2, Canada TEL: 1-877-283-5901 PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico, D.F. 11000 TEL: 55-9178-4270 <KMMNF> <06E00000>...