Dynamic (Cable) - D-Link DIR-836L Manual

Section 3 - Configuration
Select Dynamic IP (DHCP) to obtain IP Address information
My Internet
Connection: automatically from your ISP. Select this option if your ISP does not give
you any IP numbers to use. This option is commonly used for cable
modem services.
Advanced Domain Name System (DNS) services enhances your Internet
Enable Advanced
performance by getting you the information and web pages you
DNS Service:
are looking for faster and more reliably. In addition, it improves your
overall Internet experience by correcting many common typo mistakes
automatically, taking you where you intended to go and saving you
valuable time.
Disclaimer: D-Link makes no warranty as to the availability, reliability,
functionality and operation of the Advanced DNS service or its features.
Enable True Gigabit
Check to enable true Gigabit routing. This will increase the through-put
Routing Connectivity:
of the WAN-LAN connectivity of the router.
Host Name: The Host Name is optional but may be required by some ISPs. Leave
blank if you are not sure.
Use Unicasting:
Check the box if you are having problems obtaining an IP address
from your ISP.
Primary/Secondary
Enter the Primary and secondary DNS server IP addresses assigned by your ISP. These addresses are usually obtained automatically
DNS Server:
from your ISP. Leave at 0.0.0.0 if you did not specifically receive these from your ISP.
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1500 is the
MTU:
default MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Copy Your PC's MAC Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-836L User Manual

Dynamic (Cable)

30