Chicago Electric 45416 Assembly And Operating Instructions Manual page 3

8. Do not overreach. Keep proper footing and balance at all times. Do not reach over or
across running machines.
9. Maintain tools with care. Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories. Inspect tool
cords periodically and, if damaged, have them repaired by an authorized technician.
10. Disconnect power. Unplug connected appliances when not in use.
11. Remove adjusting keys and wrenches. Check that keys and adjusting wrenches
are removed from the tool or machine work surface before turning on.
12. Avoid unintentional starting. Be sure that all connected appliances are Off before
starting the generator.
13. Stay alert. Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
14. Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any part
that is damaged should be properly repaired or replaced by a qualified technician. Do
not use the tool if any switch does not turn On and Off properly.
15. Guard against electric shock. Prevent body contact with grounded surfaces such as
pipes, radiators, ranges, and refrigerator enclosures.
16. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool. Approved accessories are available from Harbor Freight
Tools.
17. Do not operate tool if under the influence of alcohol or drugs. Read warning
labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the tool.
18. Use proper size and type extension cord. If an extension cord is required, it must be
of the proper size and type to supply the correct current to the tool without heating up.
Otherwise, the extension cord could melt and catch fire, or cause electrical damage to
the tool. Depending on the appliance connected to the generator, the use of an
extension cord should have a 0 to 20 amp capability (up to 50 feet), with wire size
rated at 14 AWG. Longer extension cords require larger size wire. If you are using the
tool outdoors, use an extension cord rated for outdoor use. (signified by "WA" on the
jacket).
19. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
An extension cord that is hot to the touch is overloaded. Repair or replace damaged extension
cords immediately.
SKU 45416
WARNING
Page 3 REV 04/02