Specifications ITEM DESCRIPTION Power Output 10,000 watts (maximum), 7200 watts continuous (rated); 60 Hz 2 - 120 VAC (20 amp), single phase duplex receptacle; Voltage Output 1 - 120 / 240 VAC (30 amp), single phase twistlock receptacle Motor Driver Requirements 3600 RPM, 16 HP Drive Type Belt driven 1 inch (dia.) meter;...
Page 3
Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines. Maintain tools with care. Keep tools sharp and clean for better and safer performance. Follow instructions for lubricating and changing accessories. Inspect tool cords periodically and, if damaged, have them repaired by an authorized technician.
Page 4
Electric Generator Safety Precautions and Warnings The Generator produces electrical current. Improper use can result in electrocution, injury or death. Only a qualified technician should service or repair this generator. The Generator was designed to be used in a dry area. Do not expose to rain, snow, sleet, or damp conditions.
Page 5
Note: Performance of this tool may vary depending on variations of the power driver motor. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Page 6
MOUNTING PLATE GENERATOR / ALTERNATOR 10KW SKU 45416 The customer will need to supply the following hardware (not included): 1) (4) Grade 3, 5/16” -18 x 1-1/4”L hex-head bolts 2) (4) 5/16” -18 hex nuts 3) (4) 5/16” lock washers 4) (4) 5/16”...
Unpacking When unpacking, check to make sure the Generator is complete. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible. Installation Verify that the driver motor is securely mounted to a stable surface (see Mounting Plate instructions on pages 5 and 6), and belt pulleys properly attached.
When you are finished using the Generator, stop the motor driver, then disconnect the appliances. Over Current Reset Buttons 120 Volt Duplex 120 / 240 Volt Outlet Twistlock Outlet Maintenance WARNING: Before performing any maintenance on the Generator, the motor driver must be off, and the Generator must be allowed to cool down after use.
Parts List Item # Description Over Current Protector (20 amp) 2 Over Current Protector (30 amp) 2 Spring washer, GB93-87, M4 AC Socket, 120V/120V AC Socket, 120V/240V Bolt, GB818-85, M5x12 Spring Washer, GB93-87, M5 Washer, GB 97.1-85, 5 Over Current Protector Nut Over Current Protector Washer Wiring Box Bolt, GB5783-B6, M4x10...
Assembly Drawing Note: Voltmeters (#29) located on Wiring Box are not shown. NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. SKU 45416 Page 10 REV 04/02; 04/03; 09/03...