Table of Contents
Advertisement
Generator control illustrations
fuel
air filter cover (67) transparent
Meter (1a)
to show controls underneath.
choke
oil drain
control (80)
plug (24)
Before setting up or using the generator, familiarize yourself with the locations of
the controls and adjustments as shown above.
note: For additional information regarding the parts listed in the following pages, refer to
the assembly diagrams on pages 16 and 18 and the Generator control illus-
trations above.
pre-start checks:
Check to make sure the Engine's Power Switch (52a) is in its "off" position.
1.
iMportant! prior to first using the Generator, the engine Must be filled
2.
with approximately 1/2 (0.47) quart of a high quality sae 10w-30 grade engine
oil. To do so, unscrew and remove the Engine's Oil Dipstick (28) located at the
bottom of the Engine Crankcase. Fill the Engine's Crankcase until the oil level is
up to the upper marked line on the Dipstick. Then, screw the Dipstick back into
the Oil Fill Hole.
3.
Before use, remove the Fuel Tank Cap (2a) and fill the Fuel Tank (8a) with unleaded
gasoline. Then, replace the Fuel Tank Cap.
for technical questions, please call 1-800-444-3353.
SKU 94678
fuel Valves
recoil start
(9a, 81)
Handle (64)
operation instructions
on/off
circuit
switch (52a)
protectors
dc (59a) ac (53a)
battery charging
dipstick
outlet (57a)
(28)
ac outlets
pilot lamp
(54a)
(56a)
Voltmeter
Grounding
(58a)
point (55a)
Page 10
Hide quick links:
Advertisement
Table of Contents
