Oven Door; Leveling Legs; Storage Drawer - Maytag SMOOTHTOP 500 Use And Care Manual

Oven Door

CAUTION
• Do not place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break
the door, or injure the user.
• Do not attempt to open or close door or operate oven until
door is properly replaced.
• Never place fingers between hinge and front oven frame.
Hinge arms are spring mounted. If accidentally hit, the
hinge will slam shut against oven frame and could injure
your fingers.
To remove:
1. When cool, open the oven door to the
first stop position (about four inches).
2. Grasp door at each side. Do not use
the door handle to lift door.
3. Lift up evenly until door clears hinge arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges.
Door should not appear crooked.
Important: The oven door on a new range may feel "spongy"
when it is closed. This is normal and will decrease with use.
Oven Light
(style varies by model)
CAUTION
• Disconnect power to range before replacing light bulb.
• Allow oven to cool before replacing light bulb.
• Make sure bulb cover and bulb are cool before touching.
To replace oven light bulb:
1. When oven is cool, hold bulb cover
in place, then slide wire retainer
off cover. Important: Bulb
cover will fall if not held in
place while removing wire
retainer.
2. Remove bulb cover and light
bulb.
3. Replace with a 40-watt appliance bulb.
4. Replace bulb cover and secure with wire retainer.
5. Reconnect power to range. Reset clock.
1. Use a dry potholder and very carefully unscrew bulb cover
2. Replace with a 40-watt, oven-rated appliance bulb. Bulb
3. Replace bulb cover and reconnect power to oven.
4. Reset clock.

Leveling Legs

Be sure the range is leveled when installed.
If the range is not level, turn the leveling legs,
located at each corner of the range, until
range is level.

Storage Drawer

The storage drawer can be removed to allow you to clean
under the range.
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
BULB COVER 3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
WIRE
2. Lift up the front of the drawer and gently push in to the
RETAINER
3. Lift drawer up again and push until drawer is closed.
8
OR
and bulb.
with a brass base is recommended to prevent fusing of
bulb into socket.
CAUTION
Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor. This bracket prevents the range
from accidentally tipping.
CAUTION
Do not store plastic, paper products, food or flammable
materials in this drawer. The drawer may become too warm
for these items when the oven is in use.
first stop position.
ANTI-TIP BRACKET ANTI-TIP BRACKET
LEVELING LEG
LEVELING LEG