Scsi Bus Interface Definitions - MSI MS-9246 1U User Manual

MS-9246 1U Rackmount Server
Configure/View SCSI Controller Settings
There are 8 items in the "Configure/View SCSI Controller Settings" screen. These
items display or allow you to change the SCSI controller's settings. Use the arrow
keys to highlight the item and then press <Enter> to select the value you want in each
item or enter each item's sub-menu screen.
Options

SCSI Bus Interface Definitions

SCSI Controller ID ................................... 7
SCSI Controller Parity .............................. Enabled
SCSI Controller Termination ................... Enabled
Additional Options
Boot Device Configuration ...................... Press <Enter>
SCSI Device Configuration ...................... Press <Enter>
Advanced Configuration .......................... Press <Enter>
BIOS Information
Interrupt (IRQ) Channel ........................... 11
I/O Port Address ........................................ B000h, B400h
SCSI Controller ID
The item is used to assign a SCSI ID to the SCSI controller. It is recommended that you
should leave the default setting unchanged. Settings: [0]~[15].
SCSI Controller Parity
Use the field to enable or disable SCSI parity error checking function. If any of your
SCSI devices does not support parity checking, disable this function. While disabling
the function, you should disable disconnections for all devices, as parity checking for
the reselection phase is NOT disabled. A non-parity device's I/O operation will never
complete if the reselection fails due to a parity error.
SCSI Controller Termination
In order to have the SCSI bus function properly and reliably, termination at the ends of
A-4
AIC-7902 A at slot 0D, 03:07:00
<F6> -- Reset to SCSI Controller Defaults
SCSI Bus Interface Definitions