Removing The Keyboard - Panasonic CF-T4GWCTZ1 Service Manual

2.2. Disassembly
2.2.1. Preparation
Attention:
Before disassembly, be sure to perform the following steps.
1. End the Windows.
2. Turn off the power and then remove the AC adaptor.
3. Slide the hooks (A) and then remove the battery pack.
4. Remove the screw (A) and then remove the DIMM cover.
(Remove if the DIMM memory is equipped with)
Screw (A) : XSB2+4FNL(N16)
Baattrey Pack
Screw(A)
2.2.2.

Removing the Keyboard

Preparation : perform the section 2.2.1. first.
1. Remove the 4 screws (B).
Screw(B):DXQT2+E12FNL(N11)
2. Remove the 2 keyboard hook plates, and then remove the
hook of back side of keyboard with screw driver.
Screw(B)
Hook(A)
DIMM Cover
Keyboard Hook Plate
Screw(B)
Screw(B)
Keyboard Hook Plate
3. The LCD unit is opened up to about 90° by operating the
LCD knob.
4. Remove the 6 hooks (B).
5. Open the keyboard from LCD side and then turn it inside
out on the top case.
Note:
It can remove with the keyboard hook plate.
LCD Unit
LCD Knob
6. Remove the heat spreader from buttom of the keyboard.
7. Remove the keyboard FFC from the connector (CN15) and
then remove the keyboard.
KeyBoard
CN15
2-2
Hook(B)
Hook(B)
Heat Spreader