Table of Contents
Advertisement
3 Reassenbly instructions
3.1.
Attention when CF-T4G series is repaired
· Please execute writing BIOS ID when you exchange the main board.
· Parts (sheet and rubber) etc. related various the conductive cloth and heat spreader cannot be recycled. Use new parts.
3.2.
Assembly knowhow of part LCD
LCD rubber, LCD side rubber and LCD backing rubber's putting
LCD Rubber (Upper
LCD Side Rubber
LCD cable processing
Clamping processing of LCD cable, LCD connector connection and putting of PET tape of cable
The LCD insulation sheet is peeled off.
The LCD cable is processed to the LCD frame clamping.
The LCD cable is connected with the connector.
The PET tape is put.
Putting of the conductive cloth
The conductive cloth is put and after putting a both side tape is put.
Process the part in the Signal line of the LCD cable in the conductive cloth.
Put the conductive cloth on the connector surely.
There must not be beginning to see from externals.
LCD Back Rubber(Lower)
LCD Front Case
LCD Insulation Sheet
A red line of the cable is matched to the LCD frame externals.
Connector of externals match
LCD Insulation Sheet
LCD Rubber(Upper)
LCD Front Case
Big
Small
1 2mm
PET Tape
Connector
Both Side Tape
3-1
Be parallel after putting
1 2mm
Connector
LCD Frame Clamp
0 1mm
Insulation Sheet of edge match
0 1mm
Conductive Cloth
(LCD Label)
LCD Cable
Advertisement
Table of Contents
