Chicago Electric 95380 Set Up And Operating Instructions Manual page 8

3. The tool must be plugged into an appropriate outlet, properly installed and
grounded in accordance with all codes and ordinances. The plug and outlet
should look like those in the following illustration.
(See 3-Prong Plug and Outlet.)
THE
ROUTER TABLE
POWER CORD
USES A
3-PRONG PLUG
3-Prong Plug and Outlet
Double Insulated Tools: Tools with Two Prong Plugs
1. Tools marked "Double Insulated" do not require grounding. They have a special
double insulation system which satisfies OSHA requirements and complies
with the applicable standards of Underwriters Laboratories, Inc., the Canadian
Standard Association, and the National Electrical Code.
(See Outlets for 2-Prong Plug.)
2. Double insulated tools may be used in either of the 120 volt outlets
shown in the preceding illustration. (See Outlets for 2-Prong Plug.)
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
When unpacking, check to make sure all the parts shown on the Parts List on
pages 16 and 17 are included. If any parts are missing or broken, please call Harbor
Freight Tools at the number shown on the cover of this manual as soon as possible.
SKU 95380 For technical questions, please call 1-800-444-3353
Outlets for 2-Prong Plug
Symbology
V~
A
n 0 xxxx/min.
UNPACKING
Volts Alternating Current
Amperes
No Load Revolutions
per Minute (RPM)
PAGE 8