Epson Stylus COLOR 880 Service Manual page 146

EPSON Stylus COLOR 880
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
"CARRIAGE ASSEMBLY"
<Lubrications Type> G-55
<Lubrication Amount>
15
0.05~ 0.07g
Note:
This is the amount to be applied to a
new "CARRIAGE ASSEMBLY"
<Lubrication Point>
Shaft for "FRAME, LEFT"
16 <Lubricant Type> G-26
<Lubrication Amount>
φ
1 x 5mm
<Lubrication Point>
Inside of the right hole of "FRAME,
ASF; B"
<Lubricant Type> G-26
17
<Lubrication Amount>
φ
1 x 1mm
Apply grease evenly to the inside of the
hole.
<Lubrication Point>
Left and right edges of "HOPPER
ASSEMBLY; C"
18
<Lubricant Type> G-26
<Lubrication Amount>
2mm-diameter ball
Maintenance
Remarks
Apply grease with the syringe while
rotating the "SHAFT,CR,GUIDE".
Move the "SHAFT,CR,GUIDE" to
the left and right to spread the
grease.
Verify that grease can be seen on
the outside of the bearing.
See page 150
See page 150
Use a brush to apply grease.
See page 150
Use a brush to apply grease.
See page 151
Overview
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
"GUIDE PLATE, CR" (the part where
the carriage slides on.)
19
<Lubricant Type> G-26
<Lubrication Amount>
φ
1 x approx. 270mm
Revision A
Remarks
See page 151
146