Epson Stylus COLOR 880 Service Manual page 108

EPSON Stylus COLOR 880
4.2.4.7.1 Disassembling the CR Assembly
1) Remove the Printhead Unit. (Refer to Section 4.2.4.1)
2) Remove the I/C Detector Holder by releasing the four hooks.
Refer to Figure 4-46.
Hooks for the I/C
Detector Holder
Figure 4-48. Removing the I/C Detector Holder
3) Remove the I/C Detector from the CR assembly.
Figure 4-49. Removing the I/C Detector
Disassembly and Assembly
CR Assembly
I/C Detector Holder
I/C Detector
Disassembly Procedures
4) Remove the CR Encoder Board Assembly from the CR Frame as shown in
Figure 4-50.
CR Encoder Board Assembly
CR Assembly
Figure 4-50. Removing the CR Encoder Board Assy.
5) Remove the CR Timing Belt from the gutter in the CR Frame.
Make sure that the Torsion Spring 1.08 is hung onto
the protrusion of the I/C Detector Lever and the
hook on the CR frame correctly. Refer to Figure
4-51.
Ensure that the I/C Detector Cables are placed
along the gutters as Figure 4-52.
Make sure that the I/C Detector Lever acts correctly.
Revision A
108