Disassembly And Assembly - Epson DLQ-3000 Service Manual

3.2 Disassembly and Assembly

This section describes how to disassemble the printer. Unless otherwise specified, no
assembly procedures are included, since it is usually performed by reversing the
disassembly procedures. Points to note at disassembling and assembling are described
under the heading WORK POINTS. Adjustments required after assembling are described
under the heading REQUIRED ADJUSTMENTS. Be sure to follow the instructions and perform
any necessary adjustments. The procedure for disassembling the main component is
shown below:
1) Printhead replacement
2) Rear cover removal
3) Electrical board removal
4) Control panel removal
5) Upper housing assembly removal
6) Printer mechanism disassembly
Refer to the exploded diagrams in Appendix for detailed part engagement and location.
Note) Perform "Control program reload" when C210 MAIN and sub boards are replaced.
Rev. A
Figure 3-1. Disassembly Flowchart
Disassembly and Assembly
3-3