Functions At Power On - Epson DLQ-3000 Service Manual

1.5.3 Functions at Power On

This printer has the following 7 service modes. To enter each mode, press specified button
(buttons) while holding down the Power switch.
Y
Test Printing
Button
Result
Exit
Interface state
Y
Hex Dump Mode
Buttons
Result
(period) is
Exit
Y
Setting Printing
Button
Result
Exit
printer
Interface State
Note: In each mode mentioned above, when the printer fails to load paper, the printer goes
into the Paper-out error status. In this case, insert a sheet and press the Load/Eject
button. (In the Hex Dump mode, the message "Hex Dump" is printed at first. Then the
printer waits for data.)
Y
Bi-D adjustment (Refer to Section 1.5.4.)
Button
Y
Program Reload Mode (Refer to Section 1.5.5.)
Buttons
Y
EEPROM Clear
Buttons
Result
Y
Clear the driving line count for ribbon changing timing
Button
Result
Rev. A
LF/FF button with the power switch On.
LQ mode:
Draft mode: Load/Eject button with the power switch On.
Alphanumeric characters are printed continuously.
Press the Pause button and turn the printer Off.
All interfaces keep a busy state during the test printing.
LF/FF and Load/Eject buttons with the power switch On.
The printer prints the message "Hex Dump" and then starts printing
received data in the both hexadecimal code and corresponding
characters. If corresponding character does not exist, "."
printed instead.
Press the Pause button to print data remaining in buffer. Then turn
off the printer to exit the mode.
SelecType button with the power switch On.
Firmware version and user changeable default setting menu
(SelecType menu) along with their options are printed with the
subtitles in the selected language.
When the printing is complete, the printed sheet or continuous paper
is ejected or fed to the tear-off position, respectively. Then the
returns to the standby status.
All the interfaces keeps a busy state during the printing.
Pause button with the power switch On.
Tear Off, LF/FF, Load/Eject and Pause buttons with the power
switch On.
SelecType, Paper Select, and Pause buttons with the power switch
On.
Resets the printer to the standard factory setting, which is not always
proper setting for each market.
(This function is used only for emergency.)
Paper Select button with the power switch On.
Clears the value for the driving line count stored in the EEPROM.
Product Description
1-45