Duerkopp Adler 550-867 Fitting Instructions Manual page 17

3.3 Pre-setting the edge regulator
4
3
Fig. 10
Ausgabe/ Edition:
06.2011
Anbauanleitung Kantenerkennung
Teilesatz 0867 590944
Fitting Instructions Edge Recognition
Kit 0867 590944
2
– Slide the edge regulator 4 as far as it will go, until the latch 2 has
snapped in.
– Loosen screw 5 and slide it to the very right of the elongated hole.
– Tighten screw 5.
– Loosen screws 3.
– Push the edge regulator 4 as far as it will go towards the sewing
foot, until the guide 1 abuts onto the sewing foot.
– Tighten screws 3.
8
Fig. 12
– Loosen screws 6 and 7.
– Set the light barrier in a way that it does not hit the needle bar
when swinging.
– Tighten screws 6 and 7.
Änderungsindex
Rev. index:
0.00
1
Fig. 11
6
Printed in Germany
Teile-Nr. / Part-No.:
0791 550702
5
7
Blatt:
Sheet: 17 from 24
von