Duerkopp Adler 550-867 Fitting Instructions Manual page 15

3.2 Connecting the cables
3.2.1 Connecting the signal line
2
Fig. 4
Fig. 6
Ausgabe/ Edition:
06.2011
Anbauanleitung Kantenerkennung
Teilesatz 0867 590944
Fitting Instructions Edge Recognition
Kit 0867 590944
1
– Conduct the cable 2 along an arc under the bracket 1.
– Conduct the cable through the cable duct 3 and under the cover 5.
– Pull the cable through the table top.
– Put the cable through the free passage 6 of the control cabinet.
– Connect the open-wire of the cable 2 by screwing it to the ground-
ing plate 9 of the control cabinet using the clamp 10.
– Plug the cable connector to the socket 8 of the PCB 7.
Änderungsindex
Rev. index:
0.00
5
Fig. 5
9
6
8
Fig. 7
Printed in Germany
Teile-Nr. / Part-No.:
0791 550702
3
2
10
7
Blatt: von
Sheet: 15 from 24