Threading The Needle Thread - Duerkopp Adler 506 Operating Instructions Manual

2.3 Threading the Needle Thread

10
Caution Risk of Injury !
Turn the main switch off.
Thread the needle thread only with the unit turned off.
The threading of the needle thread occurs as shown in the pictures
alongside in increasing numerical order:
–
Place the yarn roll on the yarn stand.
–
Thread the thread through the holes 1 of the yarn stand.
–
Thread the thread through thread guide 2.
–
Lead the thread through between the tension disks of the first
needle thread tension 3.
–
Thread the thread consecutively through thread guides 4 and 5.
–
Guide the thread through between the tension disks of the second
needle thread tension 6.
–
Thread the thread consecutively through the hole in the thread pull
7 and thread guide 8.
–
Wind the thread from the bottom approx. two times around the
thread roller 9.
–
Guide the thread through the thread controller spring 10.
–
Guide the thread under the thread guide 12.
–
Open the head cover.
–
Thread the thread through the hole in the thread lever 13.
–
Guide the thread through the hole in the thread control plate 14.
–
Insert the thread from the side into the thread gripper 15.
–
Thread the thread through the thread guide 17 on the needle bar.
–
Thread the thread from the front to the back through the eye of the
needle.
1