Bobbin Winder - Duerkopp Adler 506 Operating Instructions Manual

3. Bobbin winder

2 3
1
4 5 6
Reeling on the spool thread
–
Place yarn reel on reel stand.
–
Thread the thread through the holes 1 in the reel stand.
–
Pass the thread through the tension discs of tensioner 2.
–
Pass the thread through the tension discs of tensioner 3 of the reel.
–
Pass the thread through the slot in guide 4.
–
Pass the thread through the hole 7 in the empty reel.
–
Place the empty reel on the bobbin shaft 8.
The pin 10 of the bobbin shaft must fit into the hole 7.
–
Pass the thread through the star 10 and clamp it in the tensioner 11.
–
Use the thread clipper 6 to cut off the end of the thread.
–
Raise the thread layer 5.
The bobbin winder is switched on and the winding process begins.
–
As soon as the reel is full the thread layer 5 springs back into
position and the winding process is terminated.
7 8 9 10 11
15