System Utility Commands (Continued) - Linear ACCESS AE-100 Guide Facility Manager’s Manual

System Utility Commands (Continued)

Timed Access Relay Latch
For servicing or testing, while in Programming Mode, the access relay
can be latched manually from the keypad for a period of hours.
1. Press
2. Enter the amount of time in hours (01-98) for the access relay to latch.
3. Press
Latch Access Relay
For servicing or testing, while in Programming Mode, the access relay
can be latched manually from the keypad for an indefi nite period of time.
✦ NOTE: This command will reset and override and timed access relay latch
set by PPN 80.
1. Press
Release Access Relay
For servicing or testing, while in Programming Mode, this command
will release the access relay if it has been manually latched (timed or
indefi nite).
1. Press
Delete All Directory Entries
This utility command will permanently erase all Directory Codes, Names,
Telephone Numbers, and resident's Entry Codes.
CAUTION: This utility command will erase ALL the Directory Entries in the
unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. Press again for verifi cation.
Delete All Stand-alone Entry Codes
This utility command will permanently erase all Stand-alone Entry
Codes.
CAUTION: This utility command will erase ALL the Stand-alone Entry
Codes in the unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. Press again for verifi cation.
STANDARD PROGRAMMING METHOD
TIMED ACCESS RELAY LATCH
HOURS = RELAY LATCH TIME IN HOURS (01-98)
LATCH ACCESS RELAY
RELEASE ACCESS RELAY
DELETE ALL DIRECTORY ENTRIES
DELETE ALL STAND-ALONE ENTRY CODES
80#HOURS#
81#
83#
92#92#
93#93#
PPN 80
PPN 81
PPN 83
PPN 92
PPN 93
13