System Utility Commands - Linear ACCESS AE-100 Guide Facility Manager’s Manual

System Utility Commands

Several utility commands are available for the system. Utility commands
can be used to copy data to other units in a multi-unit installation, clear
memory, and control the relays.
For each of the following steps, enter the Master Password and enter
Programming Mode (if the unit is not already in that mode). Exit
Programming Mode when all programming is complete.
Copy Access Data Only from Master to Sub-units
To synchronize programming in multi-unit installations, the Directory
Entries and Stand-alone Entry Codes can be copied from the master unit
to selected sub-units.
✦ NOTE: The installer must setup the system as a multi-unit installation before
this command will operate.
✦ NOTE: This utility command can only be performed from the "master" unit.
CAUTION: This utility command will overwrite ALL the access data in the
selected sub-units.
1. Press
2. Enter the unit number(s) of all of the sub-units to receive the access data.
Examples:
• To copy to unit two only enter
• To copy to unit three only enter
• To copy to units two & three enter
• To copy to units two, three, and four enter
3. To execute the command, enter
entry will abort the command).
Copy All Data from Master to Sub-units
To synchronize programming in multi-unit installations, all system
data can be copied from the master unit to selected sub-units. This data
includes the Directory Entries, Stand-alone Entry Code data, and all
system option settings (except the sub-unit number and password).
✦ NOTE: The installer must setup the system as a multi-unit installation before
this command will operate.
✦ NOTE: This utility command can only be performed from the "master" unit.
CAUTION: This utility command will overwrite ALL the data in the selected
sub-units.
1. Press
2. Enter the unit number(s) of all of the sub-units to receive the full data set.
Examples:
• To copy to unit two only enter
• To copy to unit three only enter
• To copy to units two & three enter
• To copy to units two, three, and four enter
3. To execute the command, enter
entry will abort the command).
12
STANDARD PROGRAMMING METHOD
or enter to exit (any other
or enter to exit (any other
COPY ACCESS DATA ONLY FROM MASTER TO SUB-UNITS
30#SUB-UNITS#5#
SUB-UNITS = EACH SUB-UNIT NUMBER (2-4) TO COPY
ACCESS DATA TO IN A MULTI-UNIT INSTALLATION
TO ALLOW FOR MULTI-UNIT NETWORK COMMUNICATIONS,
WHEN EXECUTING THIS COMMAND REMOTELY OVER THE
TELEPHONE, THE SYSTEM WILL DISCONNECT YOUR CALL
AFTER STEP #3 THEN COPY THE DATA FROM THE MASTER
UNIT TO THE SUB-UNITS.
COPY ALL DATA FROM MASTER TO SUB-UNITS
34#SUB-UNITS#5#
SUB-UNITS = EACH SUB-UNIT NUMBER (2-4) TO COPY
ALL DATA TO IN A MULTI-UNIT INSTALLATION
TO ALLOW FOR MULTI-UNIT NETWORK COMMUNICATIONS,
WHEN EXECUTING THIS COMMAND REMOTELY OVER THE
TELEPHONE, THE SYSTEM WILL DISCONNECT YOUR CALL
AFTER STEP #3 THEN COPY THE DATA FROM THE MASTER
UNIT TO THE SUB-UNITS.
PPN 30
NOTE:
PPN 34
NOTE: