Removing The Motor, Pf - Epson LQ-1070 Service Manual

3.2.5.2 Removing the MOTOR, PF

1. Remove the PRINTER MECHANISM from the HOUSING ASSY., LOWER(see Section 3.2.4).
2. Remove the COMPRESSION SPRING, 200 that holds the platen shaft.
3. Release the two clips holding the MOTOR,
4. Remove the MOTOR,
See Section 3.2.5.13 for details on arranging and positioning the motor cable.
3.2.5.3 Removing the FFC (CABLE, HEAD, FRONT(,REAR))
Remove the printhead (see Section 3.2. 1).
Remove the PRINTER MECHANISM from the HOUSING ASSY., LOWER (see Section 3.2.4).
2.
3. Remove the FFC from the clips that hold it along the rear side of the PRINTER MECHANISM. Make
sure that the FFC is free.
Remove the FFC from clip on the HOLDING PLATE, FFC at the rear of the PRINTER MECHANISM.
4.
Remove the four clips that hold the HOLDING PLATE, FFC to the base frame. Remove the FFC together
5.
with the HOLDING PLATE, FFC.
See Section 3.2.5.13 for details on arranging and positioning the FFC.
from the FRAME, MAIN, RIGHT.
Figure 3-12. Removing the MOTOR, PF
Point to Note for Assembly
.
.
Figure 3-13. Removing the FFC Cable
Point to Note for Assembly
3-11
the FRAME, MAIN, RIGHT.
FRAME, MAIN, RIGHT
CABLE, HEAD, FRONT
CABLE, HEAD, REAR
I
REV.-B