Table of Contents
Advertisement
H. USING MANUAL CONTROLS
If necessary, use the manual controls on Manual Input Terminal TB2 (OPEN, CLOSE,
and STOP, as shown in Figure 13), to move the gate for system installation.
•
To open the gate: connect the OPEN and STOP terminals to the COMMON
terminal.
To close the gate: connect the CLOSE and STOP terminals to the COMMON
•
terminal.
•
To stop the gate: disconnect the STOP terminal from the COMMON terminal.
If the STOP terminal is disconnected from the Common terminal, the gate is
prevented from moving and no command will affect the gate.
Rev J
Figure 13. Manual Controls, Location and Operation.
IMPORTANT NOTE
Doc 01-20098
Page 14 of 44
Advertisement
Table of Contents
