Table of Contents
Advertisement
N. FINAL ASSEMBLY OF GATE OPERATOR
Gate Operator
Cover (in place)
Cover
Mounting
Bolt
(4 places)
1. Install clear cover on gate operator control box.
2. Make sure that gate operator unit power switch is turned on.
3. Install gate operator cover and secure with four bolts.
4. Turn on power to the gate operator at the circuit breaker.
5. Cycle the gate to ensure it is operating properly.
Rev J
Clear Plastic
Cover
Control
Box
Figure 18. Gate Operator Final Assembly.
IMPORTANT SAFETY PROCEDURE
Doc 01-20098
Gate Operator
Cover
Page 23 of 44
Advertisement
Table of Contents
