Remote Controls - Chamberlain MH5011U-RH Installation Manual

BASIC PROGRAMMING
DETERMINE THE WIRING TYPE
ALTERNATE INSTALLATION: C2 WIRING TYPE WITH MONITORED
ENTRAPMENT PROTECTION DEVICE
• Momentary contact to open and stop with constant pressure to
close.
• Open override that reverses when closing by any opening
device.
• Wiring for entrapment protection device to reverse.
NOTE: The operator will automatically convert to B2 wiring when
Monitored Entrapment Protection Device is installed.
(See accessories page for Monitored Entrapment Protection
Devices.)
• Timer-to-Close (TTC) feature not available.
MONITORED ENTRAPMENT PROTECTION DEVICE
Photoelectric Sensor
To Program:
1
Press and hold the LEARN and CLOSE buttons until the LED
goes out (approximately 3 seconds).
Electrical Box
Logic Board
D7
D5
U4 D6 D4
014A1030 J4
C32
C20
TP1 R25
C9
U1
C21
L5
^^^^
AUX ANT AUX ANT
C18
J2 R27
D14
K2
TTC LEARN STOP CLOSE OPEN LT
LED C29
R24
1 2 3 4 5 6 7
P1
LMEP1 LMEP2 STOP CLOSE OPEN
D9 COM INTRLK
To Reset to B2 with Monitored Entrapment Protection Device:
1
Press and hold the LEARN and STOP buttons until the LED
goes out (approximately 3 seconds).

REMOTE CONTROLS

MODE OPEN
B2 X
B2 with TTC X
C2 X
LEARN STOP CLOSE OPEN
D14
LED
1 2 3 4 5 6
RADIO OPERATION
CLOSE
X
X (3-button remote)
ALTERNATE INSTALLATION: C2 WIRING TYPE WITHOUT
MONITORED ENTRAPMENT PROTECTION DEVICE
(FACTORY DEFAULT)
• Momentary contact to open and stop with constant pressure to
close.
• Open override that reverses when closing by any opening
device.
• Wiring for entrapment protection device to reverse.
NOTE: The operator will automatically convert to B2 wiring when
Monitored Entrapment Protection Device is installed.
(See accessories page for Monitored Entrapment Protection
Devices.)
• Timer-to-Close (TTC) feature not available.
NON-MONITORED ENTRAPMENT PROTECTION DEVICE
Reset to FACTORY DEFAULT (C2) when the Monitored
Entrapment Protection Device has been learned and then
removed:
1
Remove any monitored entrapment protection devices.
2
Turn the main power OFF and then ON to restore the operator
to the FACTORY DEFAULT setting.
7
STOP REVERSE WHILE CLOSING
X
X
X
21
Sensing Edge
X
X
X
TTC RESET
X when open