Software Installation; General - Duerkopp Adler 530 Installation Instructions Manual

9.2 Software installation

9.2.1

General

22
Loading a specific sewing software in the DACIII control unit is
possible with the help of the "Programmed Dongle". The "Programmed
Dongle" has a label indicating the class and software version.
Such a loading (booting) may be used in order to provide several
DACIII control unit with a sewing software (first installation) or to install
a newer machine software (update).
With the delivery of the machine only the test software (allowing the
loading of sewing software) is installed in the control unit.
The test software offers no further functions. If the test software gets
damaged during the loading process, it is no longer possible to load a
software using a dongle.
In such a case use a PC with a loader cable.
The detailed procedure for this is described at the homepage of
Dürkopp Adler AG "www.duerkopp-adler.com" among the section
of "Download Area" and "Software".
The version of the software to used depends on the serial number of
control unit:
Serial numbers 0302-00101 ... 0307-00643: the control unit should be
used with an Axx.x-Version
Serial numbers 0307-00644 and higher:
used with an Bxx.x-Version
The serial number (Serien-Nr./serial no.) is written on the specification
plate of the DAC III control unit :
CAUTION !
Turn off the main switch before connecting the dongle.
the control unit should be