7.6
Replacing the shuttle bobbin
3
12
1
2
Caution – Risk of Injury !
Turn the main switch off.
Change hook thread bobbin only when automatic bartacker
is switched off.
Taking off the empty bobbin
–
Pull down hook cover 3.
–
Raise up the bobbin enclosure hood 1.
–
Take out the upper part of the bobbin enclosure 2 with the bobbin 6.
–
Remove the empty bobbin from the upper part of the bobbin
enclosure 2.
Inserting a full bobbin
–
Place full bobbin in the top of bobbin case 2.
–
Thread bobbin thread through slot 5 below tension spring 7 in the
drill-hole 4.
–
Pull out the tension spring from the bobbin enclosure 2 about
2.5 cm.
When the thread is being pulled out, the bobbin must rotate in the
direction shown by the arrow.
–
Replace bobbin housing 2.
–
Close bobbin enclosure hood 3.
7
4
5
6
2