DURKOPP ADLER Kit 0367 595084 Instructions page 4

Instructions for converting for manual backtacking
– Remove two circlips 7 from the shaft 0367 166020.
– Pull the shaft out.
– Mount the included shaft and slip circlips on.
– Tighten the pressure screws of the lever and the frame.
– Make drillhole 6H13 according to drilling template 0367 165990 (with customary 6 mm steel drill).
2
– Knock in pin 2 (part no. 0578 000868).
– Knock pin 8 (part no. 0994 271360) in the
drillhole already existing and put the included
piece of hose 10 (part no. 0367 165980)
on the pin.
– Put lever 3 (part no. 0367 165960) on shaft.
– Hang in spring 4 (part no. 0667 165220).
– Put clamping block 5 (part no. 0367 166003)
on shaft
With the maximum stitch length the pin 9 of
the clamping block 0367 166003 must abut on
lever 0367 165960.
– Tighten screw 6 at the clamping block 5.
– Fasten handle 13 on lever 3 with screws 14
(9204 201667).
– Adjusting the stitch length: see service
instructions chapter 2.3
– Adjusting the short tail trimmer
(only with cl. 0367-170315 and 0367-180315):
see service instructions chapter 2.9
– Mount valve cover, included belt protection,
handwheel and synchronizer
.
Ausgabe/Edition:
01. 2006
Umbauanleitung für Handverriegelung
Teilesatz 0367 595084
Kit 0367 595084
Printed in Federal Republic of Germany
Teile-Nr./ Part-No.:
13 14 3
9 5
Blatt:
Sheet: 4
0791 367770
4
6
von
from 4