Square Wave Output - UNI-T UT20B Operating Manual

Model UT20B: OPERATING MANUAL
Measurement Operation (5)
C. Square Wave Output
Warning
To avoid damages to the Meter, do not allow output terminals to reach higher
than 10V.
To measure square wave output proceed as follows:
1. Set the rotary switch to
2. Connect the test leads across with the object being measured.
The measured value shows on the display.
Note
l
The frequency is approx. 50Hz.
l
The output voltage range will be over 3Vpp when it is loaded 1M .
l
When square wave output testing has been completed, disconnect the connection
between the testing leads and the circuit under test.
.
15