Altering Parameter Values - Duerkopp Adler 69 Operating Instructions Manual

6.3.2

Altering parameter values

A operator level parameter values are changed with the four program buttons ("G", "F",
"+", "-") on the right-hand side of the operating panel.
The parameter list on the next page gives all parameters which can be altered at
operator level.
1. Selecting programming mode
-
Turn on the main switch.
"MANUAL" appears in the display.
-
Press and hold down the "G" button.
-
Press the "-" button.
"- - - - - - >F" appears in the display.
-
Release both buttons.
The control unit is in programming mode.
NB:
The sewing drive is inoperative in programming mode.
2. Selecting parameter number
-
Press the "G" button.
The button must be pressed repeatedly until the group number (e.g. 6xx) appears.
-
Press the "F" button repeatedly until the required parameter number appears in
the display (e.g. "102*0002").
If the "F" button is held down the parameter number continues to change until it is
released.
3. Changing the displayed parameter value-
-
Use the "+" and "-" buttons to increase or reduce the parameter value.
If the "+" or "-" button is held down the parameter number continues to change un-
til it is released.
-
If you leave the parameter-number routine the last-displayed parameter value is
automatically saved.
4. Leaving programming mode
-
Simultaneously press the "G" and "-" buttons.
The control unit leaves programming mode.
The last-displayed parameter value is saved.
-
"MANUAL" appears in the display.
-
The control unit is ready for use.
The new settings can be checked by executing a test seam.
30