Table of Contents
Advertisement
5.14 Welting
1
2
The rapid-adjustment welt-guide mechanism with three positions is used to sew welts
between two layers of material. It can be swivelled in or out at the beginning and end of
the seam.
Four welt guides 2 are available (sewing attachments E20 - E23) with welt grooves from
3 to 6 mm.
Inserting the welt
–
Undo screw 1.
–
Feed welt in through welt guide 2.
–
Adjust welt guide 2 to the width of the welt.
The welt must be guided at the sides, but at the same time it must be easy to pull it
through the welt guide 2.
–
Tighten screw 1.
Sewing in the welt
–
Lay the welt between the two layers of material.
–
Pull out ball handle 4 and turn lever 3 as far as it will go to the left (position P).
–
Start sewing until the needle has reached approximately the middle of the welt.
–
To continue sewing in the welt pull out ball handle 4 and turn lever 3 to the centre
position (position S), where it engages.
–
At the end of the seam pull out ball handle 4 and turn lever 3 to its basic position
(position 0).
Caution: danger of injury
Turn off the main switch.
The welt may only be inserted with the sewing machine
switched off.
3
4
21
Hide quick links:
Advertisement
Table of Contents
