Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dual XC4100
Summary of Contents for Dual XC4100
- Page 1 XC4100 INSTALLATION/OWNER'S MANUAL AM/FM/Cassette Receiver...
- Page 2 XC4100 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started •...
-
Page 3: Installation
XC4100 INSTALLATION Installation Typical DIN Mounting Typical 2-Shaft Mounting... -
Page 4: Wiring Diagram
XC4100 INSTALLATION Wiring Diagram FUSES: When replacing fuses, make sure the new fuse is the correct type and amperage rating. Using an incorrect fuse could damage the radio. The XC4100 uses one 3 amp AGC fuse (Ignition) and one 0.5 amp AGC fuse (Remote turn-on) located in-line. * Caution - Do not attach any speaker leads to ground as severe damage will occur. -
Page 5: Control Locations
XC4100 OPERATION Control Locations Power/Volume Tuning Band Balance Stereo Indicator Bass Boost FM Indicator Auxiliary Input Mono/Stereo Eject/Fast Forward General Operation Power On/Off Turn POWER knob clockwise to turn the unit on. Turn POWER knob counter-clockwise until a click is heard to turn the unit off. Cassette Mode Insert a cassette to begin playback. Tuner Mode Turn POWER knob clockwise or eject cassette to begin or resume tuner operation. -
Page 6: Tuner Operation
XC4100 OPERATION General Operation Bass Boost Press BASS to activate and deactivate bass boost curve. Activating this feature will enhance the bass frequencies when listening to music at all volumes. Volume Adjust volume by turning VOL knob clockwise or counter-clockwise. Balance Adjust balance by turning BAL knob clockwise or counter-clockwise. -
Page 7: Limited One Year Warranty
A slight adjustment of any custom Dual Electronics Corp. warrants this product to controls may save you a service call. the original purchaser to be free from defects in material and workmanship for a period of one 2. -
Page 8: Specifications
General Power supply: 11-16 VDC, negative ground Speaker output impedance: 4 ohms Fuses: 3 amp fast blow AGC, 0.5 amp fast blow AGC Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm) Design and specifications subject to change without notice. CEA-2006 Power Standard Specifications (reference: 14.4VDC +/- 0.2V, 20Hz~20kHz) Power Output: 4 Watts RMS x 2 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 40dBA (reference: 1 watt into 4 ohms) Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2009 Dual Electronics Corp. All rights reserved. Other trademarks and trade names are those of their respective owners. NSA0509-V01...