Related Manuals for Dual XHD6420
Summary of Contents for Dual XHD6420
- Page 1 XHD6420 INSTALLATION/OWNER'S MANUAL AM/FM/CD/MP3/WMA/3.5mm Receiver with Built-In HD Radio™ and Detachable Face...
-
Page 2: Preparation
XHD6420 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. -
Page 3: Wiring Diagram
XHD6420 INSTALLATION Wiring Diagram Antenna Connector FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XHD640 uses one 10 amp ATM fuse located beside the wiring connector. -
Page 4: Control Locations - Receiver
XHD6420 OPERATION Control Locations - Receiver Release Eject Mode/Search Volume/Audio/Setup Tune/Track Up IR Remote Sensor Loudness EQ/Key 9 Display/Key 0 Auxiliary Input Tuner Scan/Key 8 Key 7 The XHD640 allows playback of your favorite MP and WMA files recorded on CD-R and CD-RW discs. Its powerful on-board DSP processor decodes the compressed audio while maintaining near-CD sound quality. -
Page 5: General Operation
XHD6420 OPERATION General Operation Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Semi-Permanent Remove trim ring and install supplied #1 x 7/” Phillips Faceplate Installation head screw through left side of mounting frame into faceplate. -
Page 6: Setup Menu
XHD6420 OPERATION General Operation Set the Clock Setup Menu Setup Menu Menu Function Clock Display CLK OFF CLK ON Auxiliary Input AUX ON AUX OFF Beep Confirmation BEEP OFF BEEP ON Local/Distance LOC OFF Tuning LOC ON Power on Message MSG OFF MSG ON Demonstration DEMO OFF Mode DEMO ON Display Scrolling SCRL ON... - Page 7 XHD6420 OPERATION General Operation Press rotary encoder momentarily to select between Audio Volume (default), Bass, Treble, Balance, & Fader. VOLUME BASS TREBLE BALANCE FADER Press rotary encoder until BAS appears then rotate encoder Bass left/right to adjust ( -6 minimum / +6 maximum). Press rotary encoder until TRE appears then rotate encoder Treble left/right to adjust ( -6 minimum / +6 maximum).
- Page 8 XHD6420 OPERATION HD Radio™ AM/FM Tuner Operation Analog and Digital Tuning Seek Tuning Manual Tuning Scan Tuning Storing and Recalling Station Presets The following tuning functions will access both analog and digital stations. Refer to the HD SEEK mode section on page 10 for instructions on tuning to only digital stations. Press TUNE or TUNE next strong station.
- Page 9 • Automatically Store Stations While in HD SEEK mode, press AS/PS to automatically store HD Radio stations to presets 1-6. Multicast channels (HD and/or) HD are not stored but can be accessed by pressing TUNE XHD6420 OPERATION FREQUENCY PROGRAM STATION ARTIST NAME TYPE ...
-
Page 10: Cd Player Operation
XHD6420 OPERATION CD Player Operation Insert CD Eject CD Track Select Fast Forward and Reverse Pause Scan Repeat Random CD-R/CD-RW Compatibility With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous mode of operation (tuner or AUX). - Page 11 XHD6420 OPERATION CD Player Operation - MP3/WMA Files When an MP/WMA encoded disc is first inserted, Playing an MP3/WMA Disc “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. Press DISP to select between track number/elapsed time Displaying Information (default), clock, track name, directory name, title, artist and album.
- Page 12 XHD6420 OPERATION CD Player Operation - MP3/WMA Files Refer to the following button function table when selecting, searching or navigating MP/WMA files and folders: MP3/WMA Button Function Table Button SEARCH Preset #1 Preset # Preset # Preset #4 Preset #5 Preset #6 Key #7 Key #8 Key #9 Key #0...
- Page 13 (up one level). *Only available on MP/WMA discs recorded with more than one folder. XHD6420 OPERATION " will flash in the display. to initiate the selected alphanumeric search. to select the desired file or folder. If a folder is "...
- Page 14 XHD6420 OPERATION CD Player Operation - MP3/WMA Files Navigating Note *Folder Access File Repeat File Repeat (Current Folder Only) Disc Random Folder Random Disc Intro Folder Intro After navigating by direct select, alphanumeric search or file/folder navigate modes, the track number and elapsed time will be displayed by default. Press DISP momentarily to select clock, track name, directory name, title, artist and album.
- Page 15 CD Player Operation - MP3/WMA Files Media Compatibility Playback Order Compatible Recording Formats XHD6420 OPERATION The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management).
- Page 16 XHD6420 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA Information Sampling Frequency Rates Transfer Bit rates MP3 Tag Display Recommended Settings An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP/WMA files, the unit will play the MP/WMA files only.
-
Page 17: Limited One Year Warranty
This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. -
Page 18: Troubleshooting
XHD6420 OPERATION Troubleshooting Problem Yellow wire not connected or incorrect voltage Unit will not turn on Red wire not connected or incorrect voltage (no power) Black wire not connected Fuse blown Speaker wires not connected Unit has power One or more speaker wires touching each (but no sound) other or touching chassis ground Yellow or red wire touching chassis ground Unit blows fuses... -
Page 19: Specifications
CEA-006 Power Standard Specifications (reference: 14.4VDC +/- 0.V, 0Hz~0kHz) Power Output: 17 Watts RMS x 4 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms) XHD6420 OPERATION Specifications 10Hz-0kHz >65dB 1 Bit 87.5MHz-108.1MHz... - Page 20 Dual Electronics Corp. Toll Free: 1-866-8-5476 www.dualav.com ©007 Dual Electronics Corp. All rights reserved. Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and or other countries. HD Radio™ Technology Manufactured Under License from iBiquity Digital Corporation. U.S. and Foreign Patents.