Programming; Espresso Pour Volume - Sunbeam EM9300 Caffe Bellissimo Instruction Booklet

Programming
Programming the espresso pour volume in bean
mode
The coffee machine is set for standard
quantities by default. However, you can set
the cup filling level individually for each cup
size.
Press the (A) button repeatedly until the
required cup symbol for the desired ground
coffee quantity is displayed.
Note: The cup filling level for one cup is
stored during this process.
Place an appropriate cup under the coffee
delivery spout.
Press the (A) button repeatedly until the
symbol for the ground coffee quantity you
desire is displayed.
Press the oK button and hold it pressed
until the desired cup filling level is
reached.
Release the button. The new cup filling
level is now stored.
Repeat the procedure if you also wish to
change the filling level for the other cup
sizes.
All values remain stored even when the
coffee machine is switched off. Should you
change your cup size, you can adapt the cup
filling level individually at any time or reset
the filling level with a "Reset". The settings
affected are described on page 28, Restoring
the factory default settings
The stored cup filling levels for each
individual cup symbol only applies in bean
mode.
Programming the espresso pour volume in
pre-ground mode
The coffee machine is set for standard
quantities by default. However, you can set
the cup filling level individually for each cup
size. Proceed as follows:
Select the "Coffee powder" function by
pressing the (B) button 1;:l.
Press the (C) button repeatedly until the
required cup symbol for the desired ground
coffee quantity is displayed.
Place an appropriate cup under the coffee
delivery spout.
Add a maximum of one level measuring
spoon (max.8g) of pre-ground coffee.
Then press the oK button and hold it
pressed until the desired cup filling level
is reached.
Release the button. The desired cup filling
level is now stored.
Repeat the procedure if you also wish to
change the filling level for the other cup
sizes.
All values remain stored even when the
coffee machine is switched off. Should you
change your cup size, you can adapt the cup
filling level individually at any time or reset
the filling level with a "Reset". Follow the
steps described on page 28, Restoring the
factory default setting.
The stored cup filling levels for each
individual cup symbol only applies in powder
mode.
21