Advanced Programming Options - Sunbeam EM5900 Artista Instruction Booklet

Advanced Programming Options

Espresso Thermoblock Temperature
The water temperature of this espresso
machine has been calibrated to the precise
temperature of 92ºC at the group head. The
temperature of the water at the group head
can be modified in increments of 2ºC up and
down should it be desired.
To do this you need to follow the instructions
below:
1. Insert the power cord into a 230-240V
AC power outlet and switch the power
'ON' at the mains only, so that no lights
are illuminated on the espresso machine
control panel (ie. the power outlet should
be 'ON' but the espresso machine will be
'OFF').
2. Press and hold down the 'COFFEE' button
for 3 seconds.
3. While still holding down the 'COFFEE'
button briefly press the 'POWER' button
and release.
4. Release the 'COFFEE' button.
Note: This activates the programmability of
the Espresso Temperature and to signal this,
the machine will output the current setting
with a sequence of beeps. See chart below
to determine what setting your machine is
programmed to.
Beep Sequence
3 short beeps
2 short beeps
1 short beep
1 short and 1 long beep
1 long beep
2 long beeps
3 long beeps
26
Setting
+ 3
+ 2
+ 1
Factory Setting
- 1
- 2
- 3
Note: The lights behind the 'STEAM' and
'HOT WATER' buttons will start flashing.
5. Within 30 seconds press and release one
of the flashing buttons depending on the
required temperature adjustment;
Up (+) a setting : Press 'HOT WATER'
Down (-) a setting : Press 'STEAM'
Note: When you have selected a new
temperature setting the machine will sound
a sequence of beeps to indicate the new
temperature setting.
6. To save your settings press and hold down
the 'COFFEE' button for 3 seconds. A
single long beep will sound to indicate your
settings have been saved.
Note: The espresso machine will then
automatically power on and begin heating up.
Note: The machine will stay in programming
mode for up to 30 seconds. If you do not
select a new temperature setting within 30
seconds the program will automatically return
to the Factory Setting and the espresso
machine will then power on and begin
heating up.
Up (+)
Down (-)