2.
Disconnect the drive cables from the rear of the drive, or, if you are removing a media card
reader, disconnect the USB cable from the system board as indicated in the following illustration.
Figure 3-27
3.
Press down on the green drive retainer button located on the left side of the drive to disengage the
drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it
stops, then lift it up and out of the drive cage (2).
Figure 3-28
76
Chapter 3 MultiSeat ms6200 Desktop Hardware Upgrades
Disconnecting the Media Card Reader USB Cable
Removing a 3.5-inch Drive (Media Card Reader Shown)