HP Compaq MultiSeat ms6005 Hardware Reference Manual page 81

8.
Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided
four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric
guide screws are black. Refer to
the extra M3 metric guide screws location.
NOTE:
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
the new one.
CAUTION:
Use only 5-mm long screws as guide screws. Longer screws can damage the
internal components of the drive.
Figure 3-22 Installing Guide Screws in the Optical Drive
9.
Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 3-23
Installing the Optical Drive
Installing and Removing Drives on page 68 for an illustration of
Installing and Removing Drives
73