Precor EFX 532i Owner's Manual page 105

Position the water bottle holder as shown in the illustration. Place
the top section over the handrail and align the two mounting holes.
Position the base below the handrail and align the slits and
mounting pems with the top section. Slide the base into the top
section and secure it using three Phillips-head screws (F) and a
Phillips-head screwdriver.
Wrench tighten the hex head screws. Start at the base of the
stabilizers and tighten all eight screws using a ½-inch socket with
an extension. Return to the console bracket. Wrench tighten the four
side screws, and then the two bottom screws.
Remove the protective material between the yoke and the ramp
used in step 4.
532i Elliptical Fitness CrossTrainer Assembly Guide
Place the display covers (M) around the console bracket. Insert
two buttonhead screws (H) and wrench tighten.
Important: Make sure the top cover's front edge is flush with the
display console bracket before you secure it to the bottom cover.
11