Campbell Hausfeld WF2010 Operating Instructions & Parts Manual page 7

Welding Guidelines
Figure 10 - Multiple Weld Passes
Normal Heat, Wire Speed, Travel
Heat Too Low
Heat Too High
Figure 12 - Weld Appearance
Supply Cable Replacement
1. Unplug welder.
2. Remove the right side panel.
3. Disconnect the black and white
power cord wires connected to the
ON/OFF switch.
(Continued)
PUSH VS PULL TECHNIQUE
The type and thickness of the work piece
dictates which way to point the gun
nozzle. For thin materials (18 gauge and
up), the nozzle should point out in front
of the weld puddle and push the puddle
across the workpiece. For thicker steel,
the nozzle should point into the puddle
to increase weld penetration. This is
called backhand or pull technique (See
Figure 11).
Speed
4. Disconnect the green power cord
wire connected to the frame.
5. Loosen the cord strain relief screw
and pull cord through front panel.
6. Install new cord in reverse order.
Wire Speed Too Fast
7
Model WF2010
PULL
PUSH
Figure 11
Base Metal
Travel Speed Too Fast
Travel Speed Too Slow
Wire Speed Too Slow
www.chpower.com