Altering An Option Or A Running Programme; Interrupting A Programme; Opening The Door After The Programme Has Started; At The End Of The Programme - Electrolux EWG 12450 W User Manual

Altering an option or a running
programme
It is possible to change some options
before the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing
8
button .
(Only the Time Manager option
be modified after the programme has
started. )
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to O and then
to the new programme position. Start
the new programme by pressing button
8
again. The washing water in the tub
will not be emptied out.

Interrupting a programme

8
Press button to interrupt a
programme which is running, the
corresponding light starts to flash. Press
the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to O to cancel a
programme which is running. You can
now select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
8
pressing button
9
If the light goes off, the door can be
opened.
9
If the light does not go off, this
means that the machine is already
heating, that the water level is too high.
In this case the door can not be
opened.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
cannot
.
to O. After a few minutes the door can
be opened (pay attention to the
water level and temperature!).
After closing the door, it is necessary to
select the programme and options
again and press button

At the end of the programme

The machine stops automatically, the
pilot light of button
0.00
three blinking «
display. The buzzer sounds.
If a programme with an option that
ends with water still in the tub has
been selected, the pilot light
lit and the door is locked to indicate
that the water must be emptied out
before opening the door.
To empty out the water:
turn the programme selector dial to
●
O
select the Drain or the Spin
●
programme
reduce the spin speed if needed, by
●
pressing the relevant button
press button 8
●
At the end of programme, the pilot
9
lights goes off an the door can be
opened.
Turn the programme selector dial to
«O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
use electrolux 15
8
.
8
goes off and
» will appear on the
9
remains