Table of Contents
Advertisement
down. If an incorrect option is selected, the yellow pilot light of the button 8 blinks for 3
times the message Err is displayed for about a few seconds.
Select the DELAY START (Button 9)
Before you start the programme , if you wish to delay the start, press the button re-
peatedly, to select the desired delay.
The selected delay time value (up to 20 hours) will appear on the display for about 3 seconds,
then the duration of the programme will appear again.
You must select this option after you have set the programme and before you press the
button 8 .
The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by
1 hour up to a maximum of 20 hours by means of this button.
The door will be locked throughout the delay time. If you wish to add laundry in the machine
during the delay time you will press button 8 to put the machine in pause. Add the laundry,
close the door and press button 8 again.
Selecting the delayed start.
• Select the programme and the required options.
• Select the delay start.
• Press button 8 : the appliance starts its hourly countdown. The programme will start
after the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by pressing the button 8 ;
• Press button 9 once until the symbol
• Press the button 8 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with DRAIN programme.
Select an additional rinse (EXTRA RINSE)
This appliance is designed for saving water. However, for people with a very delicate skin
(allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of
water.
Press simultaneously buttons 2 and 3 for some seconds: the pilot light 10.2 comes on. This
function stays permanently on. To remove it press the same buttons again until the pilot
light 10.2 goes off.
Altering an option or a running programme
It is possible to change some options before the programme carries them out. Before you
make any change, you must pause the washing machine by pressing the button 8 .
Changing a running programme is possible only by resetting it . Turn the programme
selector dial to
pressing the 8 button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
and then to the new programme position. Start the new programme by
' is displayed;
13
Daily use
Advertisement
Table of Contents
