Cleaning The Cover, Shell And Pillows - Cal Spas LTR20101001 Owner's Manual

32
1. Open all filter covers.
2. Remove the filter baskets and filters.
3. Drain your spa completely as described in the
instructions above.
4. Remove drain plugs from the front of the pumps.
5. Disconnect the unions from both sides of the
pump.
6. Use a wet/dry vacuum to blow any remaining
water out of the jets and equipment area.
Cover your spa with a good spa cover and an all-
weather tarp to ensure that neither rain nor snow
enters the spa.
Cleaning the Cover, Shell and
Pillows
Due to the constant punishment your spa cover and
pillows receive, you should protect them by applying
Vinyl and Leather Cleaner as part of your monthly
maintenance plan. Cal Spas™ Vinyl and Leather
Cleaner is specifically designed to protect spa covers
and pillows from chemical and ultraviolet light damage.
It accomplishes this without leaving an oily residue
behind that is normally associated with common
automotive vinyl protectants.
Use of Vinyl and Leather Cleaner
Cal Spas™ Vinyl and Leather Cleaner should be used
sparingly. Incorrect usage may cause water clarity
issues.
Spa Covers
1. Remove spa cover from
spa.
2. Allow spa cover to dry
completely.
3. Spray Vinyl and Leather
Cleaner to cover evenly
wipe dry.
4. Allow spa cover to dry
completely.
5. Reinstall cover on spa.
Pillows
1. Wipe pillows dry with a soft cloth.
2. Carefully spray Vinyl and Leather Cleaner directly
onto pillow.
www.calspas.com
3. Wipe pillows dry.
4. Allow pillows to dry completely.
Warning: Do not use automotive vinyl protectants on
spa covers or pillows. These products are generally
oil-based and will cause severe water clarity issues
that are difficult to correct.
All-Purpose Cleaner (Spa
finish cleaning)
Cal Spas™ All-Purpose Cleaner is an
essential part of maintaining your
spa's finish. Through normal use,
the spa's finish can accumulate dirt,
oil, and calcium causing a rough feel
and unsightly scum lines. Cal Spas™
All-Purpose Cleaner is a low detergent, non-abrasive
cleaner specifically formulated to clean the spa without
damaging its acrylic finish.
The most effective solution to minimize cleaning time
is prevention. When the following steps are followed,
the spa's finish will actually start to resist most of the
elements that cause calcium build-up and make scum
line clean up easier.
Prior to Spa Start-Up and Refilling
1. Spray Cal Spas™ Multi-Purpose Cleaner directly
on to the spa's finish.
2. Wipe clean with a clean soft cloth.
3. Repeat on heavily calcified areas.
4. Wipe spa thoroughly with a wet sponge, rinsing
often with a bucket of clean water.
5. Allow spa to dry completely.
6. Apply a coat of Cal Spas™ Fast Sheen to the spa's
entire finish with a soft towel or sponge.
7. Allow Fast Sheen to dry until white and powdery.
8. Buff clean with a soft cloth, rotating frequently.
and
Periodic Maintenance
1. Spray Cal Spas™ Multi-Purpose Cleaner directly to
the spa's finish.
2. Wipe clean with a clean soft cloth.
3. Wipe spa thoroughly with a wet sponge, rinsing
often in a bucket of clean water.
Cal Spas™ Multi-Purpose Cleaner should not be
sprayed directly into the spa water. Incorrect usage of
this product will cause water clarity issues.
2010 Portable Spa
LTR20101001, Rev. B