Table of Contents
Advertisement
Programming the MS-9600 Fire Alarm Control Panel
SECTION 3
3.1 Programming the MS-9600 Fire Alarm Control Panel
OPTION MODULES
1=ANNUNCIATORS/UDACT
2=ON BOARD DACT
3=PRINTER/PC
Option Module Screen
DACT-UD PN 51899:B1 1/25/05
Programming for DACT-UD
Refer to the MS-9600 Manual programming section for general programming
information. To program the MS-9600 FACP for use with the DACT-UD:
1. Press the Enter or Mode key to display the Read Status/Programming screen
2. Press 2 to access Programming
3. Enter the Master level password
4. Press the down arrow key twice to view the screen with the Option Modules
choice
5. Press 3 for Option Modules to access the Option Modules screen as shown to the
left
6. Program the FACP for use with the DACT-UD using the following procedure
3.1.1 On-Board DACT
The DACT-UD (Digital Alarm Communicator/Transmitter) is an optional module
which installs directly on the FACP main circuit board for communication to a
central station. Pressing 2 while viewing the Option Module Screen will cause the
following screens to be displayed:
1=ENABLED
2=PRIMARY PHONE
3=SECONDARY PHONE
On Board DACT Screen #1
1=SERVICE TERMINAL
2=CENTRAL STATION
3=MANUAL DIAL MODE
3.1.1.1 DACT-UD Enable
To enable the on-board DACT module, press 1 while viewing On Board DACT
Screen #1 until the display reads Enabled Yes. The display will toggle between
Enabled Yes and Enabled No with each press of the key.
ON BOARD DACT
ON BOARD DACT
On Board DACT Screen #2
Programming for DACT-UD
YES
17
Advertisement
Table of Contents
