Club Programming Tips; Changing The Product Settings - Precor 954i Owner's Manual

Club Programming Tips

 Always start at the Precor banner.
 Electrical power must be supplied. For self-powered equipment,
a constant power source is available if you use the optional
power adapter. Otherwise, users have to maintain the minimum
rate of motion. If you plan to program self-powered equipment,
purchasing the optional power adapter is highly recommended.
Note: If you do not use the optional power adapter during
programming mode, and the rate of motion falls below the
minimum requirements, no warning is given when the equipment
moves into its 30-second shutdown procedure.
 The club programming mode is accessed by pressing the
RESET key at the Precor banner. The remaining key presses
must occur quickly and without pause.
Note: Treadmill keys that can be used interchangeably in club
programming mode are: PAUSE/RESET and the red STOP
button. On the EFX, the CLEAR and ENTER keys perform
specific functions, but the number keypad is disabled once you
enter club programming mode.
 Changes made in the programming mode become the default
settings when the display resets to the Precor banner.
Product Owner's Manual: Club Features

Changing the Product Settings

You must be in the Programming mode before you can change the
settings.
To access the programming mode:
1. At the Precor banner, press the following keys in sequence
without pausing between selections:
RESET, 5, 6, 5, 1, 5, 6, 5
Note: A PAUSE/RESET key appears on some products and
functions the same as the RESET key.
The programming prompts appear sequentially and in a menu
format.
Figure 5: Keys used in programming mode
17