Club Features; Club Programming Tips - Precor 946i Owner's Manual

Club Features

This section is designed to show you how to customize the
equipment for your users and view useful product information. All
these features remain hidden to the users and can only be
accessed using special keypresses. These custom settings allow
you to
 Enable or disable the safety code (treadmill)
 Change the display to a different language
 Change the display to show U.S. standard or metric
measurements
 Set the maximum exercise and pause times
 Set a cool down time limit
 Set the maximum speed and incline (treadmill)
 Enable or disable hidden programs or remote access (treadmill)
 Change the auto-level setting (EFX)
 Set the resistance range (bike)
 Customize a program
 View the odometer
 Display the number of hours the equipment has been in use
 View the software versions and part numbers
 Display the serial number
 Check the program usage and error logs
Note: To review the product programming prompts and factory
default settings that can be changed through product
programming mode, refer to the following table.
Product Owner's Manual: Club Features

Club Programming Tips

 Always start at the Precor banner.
 Electrical power must be supplied. For self-powered equipment,
a constant power source is available if you use the optional
power adapter. Otherwise, users have to maintain the minimum
rate of motion. If you plan to program self-powered equipment,
purchasing the optional power adapter is highly recommended.
Note: If you do not use the optional power adapter during
programming mode, and the rate of motion falls below the
minimum requirements, no warning is given when the equipment
moves into its 30-second shutdown procedure.
 The club programming mode is accessed by pressing the
RESET key at the Precor banner. The remaining key presses
must occur quickly and without pause.
Note: Treadmill keys that can be used interchangeably in club
programming mode are: PAUSE/RESET and the red STOP
button. On the EFX, the CLEAR and ENTER keys perform
specific functions, but the number keypad is disabled once you
enter club programming mode.
 Changes made in the programming mode become the default
settings when the display resets to the Precor banner.
17