Installing The Transformer - Brother HE-800A User Manual

4. INSTALLATION
-

- . Installing the transformer

The transformer can be installed on the floor, on the work table leg (on top of the leg or on the treadle support plates)
or underneath the work table.
Check the power supply rating label on the transformer to confirm that the voltage ratings for the transformer and the
control box are identical.
1) Floor installation
2) Table leg installation (on top of table leg)
Mounting
bracket
112.5mm
3) Table leg installation (treadle support plates)
3875Q
Washer
3876Q
17
2069Q
2070Q
Screw (M5 x 8)
2071Q
4035Q
Screw (M6 x 14)
HE-800A
Select a suitable location, and place the transformer
on the floor in that location.
* Select a location where the transformer will not be an
obstruction to people walking past.
Secure the transformer to the top of the table leg using
the mounting bracket and screws.
* The mounting bracket and screws must be obtained
separately.
1. Remove the four screws (1), and then remove the
two handles (2).
2. Place the transformer on top of the two treadle
support plates (3) as shown in the diagram, and
then secure it to the handle (2) using the washers
and screws.
* The washers and screws must be obtained
separately.