Installing The Side Cover - IBM 9228 - IntelliStation Z - Pro Service Manual

Installing the side cover

To install the side cover, complete the following steps.
Figure 9. Installing the side cover
Note: The rear adapter-retaining bracket rests against the computer side cover.
You might find it easier to lay the computer on its side to install the side cover.
1. Make sure that:
2. If you removed the bezel, reinstall it before you install the side cover (see
3. Insert the tabs inside the cover into the slots on the chassis (see Figure 9).
4. Close the cover-release latch to secure the side cover in place.
5. Lock the side cover, if you unlocked it during removal.
6. Reconnect the external cables and power cords to the computer; then, connect
7. Turn on the attached devices; then, turn on the computer.
32
IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide
v All cables, adapters, and other components are installed and seated correctly.
v You have removed all work tools or parts from inside the computer.
v The cover-release latch is in the unlocked (opened) position before you install
the side cover.
"Installing the two-piece bezel" on page 35).
Note: Make sure that each tab on the side cover is in its corresponding slot
before closing the cover-release latch.
the power cords to electrical outlets.